China solar panel mounting rail/rack/clips/bracket for offgrid 1kw home power energy products on flat roof ballast/angle/top, metal steel/aluminum structure
Our quality control:
1. SGS720H salt test report
2. TUV and ISO certified
3. Mass production capbility
4. Rich experience in mega project management
5. Good relation with famous industry suppliers
Our advantages:
-Light steel structure profile production lines
6 Steel profile lines-Newzealand 8 Metalling lines (56ton/day) Raw steel from top supplliers
-Finished steel profile
C & U steel: 89, 250, 300mm Strenthened U steel Purlin Strengthened U steel roofing
Test method
Design parameters
Datasheet
Factory tour
Overview
Metalling workshop
Why choose us for your solar system PV mounting brackets?
-Super anti-rusting performance
-High precision of structure material
-Save raw material, and cost 20%
-200MW monthly production capacipty, ensures short lead production time
-Perfect finish of structure material, hence the nice solar mounting effect
Products application gallary
Our quality control:
1. SGS720H salt test report
2. TUV and ISO certified
3. Mass production capbility
4. Rich experience in mega project management
5. Good relation with famous industry suppliers
Our advantages:
-Light steel structure profile production lines
6 Steel profile lines-Newzealand 8 Metalling lines (56ton/day) Raw steel from top supplliers
-Finished steel profile
C & U steel: 89, 250, 300mm Strenthened U steel Purlin Strengthened U steel roofing
Test method
-Test method: GB/T10125-2012
-Sample placement: 15°~25° with vertical direction
-Settlement salt solution concentration: (50+/-5) g/l NaCl
-Temperature inside the test chamber: (35+/-2) ºC
-Settlement rate of salt spray: 1~2ml (80cm2.h)
-Settlement salt solution pH value (25ºC+/-2ºC): 6.5~7.2
-Exposure time: 720 hours (check once every 96 hours)
-Cleaning method: natural dry for 0.5~1.0 hours, then rinse with water of temperature not higher than 40ºC, then dry immediately.
Design parameters
-Basic wind pressure: 0.35kN/m2;
-Basic snow pressure:0.55kN/m2
-Regional limit maximum wind speed: 23.8m/s
-Stent spacing for base plate :3000mm;
-Stents Angle: 22 degree
-Stents Angle: 22 degree
Datasheet
| SPECIFICATION | |||||
| Description | Ground mounting | Roof bracket | Carport | Agricultural bracket | Single column stand |
| Field status | open area | ||||
| Max wind load | ≤60m/s | / | <46m/s | <46m/s | ≤46m/s |
| Height | Depending | ||||
| Snow load | Depending | ||||
| Tilt Angle | 0~45° | As per requirement | 0~45° | 0~30° | 0~45° |
| Mount Directions | Vertical,horizontal | ||||
| Standard | GB/T2518-2008 & GB/T10125-2012 | ||||
| Body material | S550GD+Z350 | ||||
| Bolt material | SUS304 | ||||
| Base material | Q235/Cement | ||||
| Surface treatment | Galvanized mg-al | ||||
| Warranty | 30 years life. | ||||
Factory tour
Overview
Metalling workshop
Why choose us for your solar system PV mounting brackets?
-Super anti-rusting performance
-High precision of structure material
-Save raw material, and cost 20%
-200MW monthly production capacipty, ensures short lead production time
-Perfect finish of structure material, hence the nice solar mounting effect
Products application gallary